Pass-through spray cleaning machine

Crawler ultrasonic cleaning machine.

Overview:

This equipment is suitable for removing oil, polishing paste, dust and other impurities from automobile and motorcycle parts and hardware and mechanical parts. The equipment has a spray cleaning room, an ultrasonic cleaning room, a spray rinsing room, a compressed air water cutting room, a hot air drying room, a total of 5 stations. Its working principle is to manually place the workpiece to be cleaned on the stainless steel crawler, and then clean it according to a certain process procedure and discharge the material. The equipment has beautiful appearance, reasonable structure and long service life. It is an ideal metal cleaning equipment.

This equipment has the following characteristics:

1. Automatic transmission of cleaning workpieces;

2. The upper and lower sides of the ultrasonic vibrator radiate;

3. Spray rinsing can remove residual cleaning fluid on the workpiece and reduce secondary pollution;

4. Add a storage tank and a cleaning fluid circulating filter system to ensure cleanliness;

5. The special stainless steel mesh belt is made of special technology, which makes the equipment operation safe and reliable;

6. According to the cleanliness requirements, the cleaning time can be adjusted arbitrarily;

7. The electrical part and the control box are connected to the whole machine for easy installation and operation;

8. The upper dust cover makes the equipment complete and beautiful.

The main components of the equipment:

1 set of loading and unloading stations (loading and unloading at both ends of the main line of the equipment)

Spray cleaning system 1 set

Ultrasonic cleaning system 1 set

Spray rinsing system 1 set

Compressed air water cutting system 1 set

Hot air drying system 1 set

Bracket 1 set

Stainless steel track 1 set

1 set of outer cover

Electric control system 1 set

Main process flow:

Cleaning process: manual loading→spray cleaning→ultrasonic cleaning→spray rinsing→compressed air cutting water→hot air drying→manual unloading (if there is water on the workpiece, manually use an air gun)